Skip to content

澳洲5全天计划

Home > Products > Mica Band Heaters > Resources

Thermal Corporation mica band heater resources page banner

Below is a list of resources on Mica Band Heaters to help provide you with some additional information on our custom band heater specifications, how to measure mica band heaters, and information on locating clearance holes on custom band heaters. If you have any questions on these topics or need some more information, please contact our customer service department by phone at (800) 633-2962, by email at sales@thermalcorp.com, or send us a quick message using our chat feature located at the bottom of the page.

澳洲5微信群

Tolerances 
Width±1/16"
Circumference±1/32"
Wattage at Design Voltage+5% - 10%
Standard Gap Size for 1 piece heater:5/16"
Standard Gap Size for 2 piece heater:3/16"
Standard Terminal Height:13/16"
Lowprofile Standard Terminal Height:3/8"

澳洲5在线走势图

Check out our video blog on how to properly measure mica band heaters!

diagram for measuring diameter of Thermal Corporation mica band heaters

澳洲5三期计划

When measuring the circumference of custom band heaters, measurements should be made on the inside surface from Point A to Point B whenever possible. When ordering, please inform your customer service representative of the gap size (space between Point A and Point B).

If the heater cannot be measured, then determine the barrel circumference by measuring from Point A around to Point A again. The barrel can be measured from Point B to Point C to determine Barrel O.D.

Please make sure to inform your customer service representative of required the gap size.

澳洲5走势图开奖号码

澳洲5官方开奖直播

diagram for showing hole location on a Thermal Corporation mica band heater

If hole location cannot be determined in degrees, then measurements should be made on the inside surface of the heater: (A) From the edge of gap to edge of hole, or (B) from the edge of gap to the centerline of hole.

diagram for locating clearance holes on a Thermal Corporation mica band heater

When a hole is on the centerline of the width of a heater the maximum hole size can be determined by subtracting 3/4″ from the heater width.

diagram for locating clearance holes on a Thermal Corporation mica band heater

When a hole is offset to one side of a heater there must be a minimum of 3/8″ clearance from edge of hole to edge of heater on one side of the hole

clock time diagram clock time diagram

Holes should be located in degrees or clock time if possible, this will allow for the correct placement of holes. Note: Every minute on the clock is 6°.

Written by Jennifer Taylor & Shelby Reece
Date Published: 09.10.2018
Last Updated: 03.11.2020

澳洲幸运8官方 澳洲10冷热号统计 澳洲幸运10人工计划网 澳洲8两期计划